StrongLumio door sensor plastic, 12-24V, 4A, Mini connectors, white

Door switch.
It is used to control the lighting when the door is opened. Opening the door / clearing the space in front of the switch will turn on the lighting, closing / covering it will turn off the lighting. Possibilities of connection and use see assembly instructions below.
Voltage: 12 V / 24 V DC - direct current
Maximum current: 4 A
Detection range: <10 cm Attention, dark surfaces significantly reduce the range, for to increase the range, it is possible to stick opposite the sensor, for example, a 40 mm white cap (code 283272)
Connector type: MINI. Cable length - 2x 1m. 285110 TM-extension cable 1.8m MINI connector can be used for extension.
Installation
First switch off the power supply to the transformer. Screw the switch to a suitable place, as close as possible to the door leaf so that after opening there is a free space in front of the sensor. 10 cm. Connect the cable labeled OUTPUT to the light, LED strip, etc.. Connect the cable labeled INPUT to the transformer / transformer switchboard. Only then connect the transformer to the power supply!
Caution, designed for 12 V or 24 V DC (direct current) voltage only. We recommend using the shortest possible cables due to losses and possible heating.
Setting delay or intensity is not possible. To connect the sensor/switch with one LED strip, you must use the Mini connection cable - 285094 TM-connection cable 1.8 m MINI connector. In the case of connecting several LED strips or points (max. 6 pcs., cable with Mini connector) to one sensor/switch, it is necessary to use the switchboard 356328 SAL-switchboard LED 6x MINI - MINI connector 0.25m. To connect one sensor to the Strong transformer, it is necessary to use the connecting cable 342541 STR-prop.kabel kul.kon (Jack)-MINI (female). To connect 2 - 6 sensors to one Strong transformer, it is necessary to use the switchboard 285093 SAL-switchboard LED 6x MINI connector - Jack 0.25m.

Product details on the catalog page.